AP Racing Brake Proportioning Valve Assembly - 7 Settings
General Information:
Installation To obtain the best performance using this valves, the brake balance should be biased towards the rear so that with the valve piped in to the rear line and set in position 7 where virtually no reductions occurs, the balance is as much to the rear as will ever be needed. Moving the control lever to a lower setting will progressively reduce the rear line pressure giving more bias to the front, for use when more grip is available.
Nominal Ratio of 0.325.
Weight = 180g approx.
Note:-
This proportioning valves is suitable for use with any brake fluid that conforms to DOT 3, DOT 4 or DOT 5.1 standards, but best all round performance will be achieved with 600 brake fluid.
Warning
Due to internal adjustments set by AP Racing, do not strip these assemblies. Do NOT attempt any modification of these valves. Strictly for competition use only.
AP Racing are based in Coventry, UK. They have achieved more international sporting success than any of its rivals, establishing itself as a key supplier at all levels of international motorsport formulae, including single seat racing, rallying, sports car racing, stock car racing and touring cars. In 2011 alone, AP Racing supplied either brakes, clutches or both to 30 champions across the entire spectrum of the motorsport world.
